Installation Guide

INSTALLATION SHEET
CH93824
19054 28th Avenue Surrey, BC Canada V3S 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W
20190109
: kuzcolighting.com
LED Chandelier
START FROM HERE
• Make sure power is completely off at the fuse box.
• Have your fixture installed by a qualified licensed electrician
•
Prepare everything in a clear area.
• Wear gloves at all times during this installation.
• Read instructions carefully before you start assembly.
• Keep this instruction sheet for future reference.
Technical Support: 1-855-855-8926
Please Note:
• For dimming, a TRIAC or an ELV type of dimmer is required.
1.
2.
3.
4.
Remove the fixture from its original packaging. Next, remove
the mounting plate (1c) within the canopy (2a) by removing
the screws (2b). Secure the mounting plate (1c) to the
electical junction box (1a) with screws (1d). Connect all wires
(1b) around the crossbar (1c) correctly black to black “L”,
white to white “N” and the ground wire with provided
marrettes from the hardware package. Secure the mounting
plate (1c) to the junction box (1a) with screws (1d) provided
in the hardware package. Make sure to reinforce the wood
behind the drywall for extra support and use the woodscrews
(1e) to secure the crossbar (1c) to the ceiling.
Before you mount the canopy to the mounting plate, select
the desired length you would like the fixture to hang down
from the ceiling. To set the fixture hanging height, simply push
in the sleeve (2c). Installer has the flexibility to adjust fixture
height and posture by pushing or pulling wires individually.
Release the sleeve (2c) and the wire will be held tightly in
place.
You are now ready to mount the canopy to the mounting
plate. Align the holes on the sides of canopy (2a) with the
holes on the sides of mounting plate (1c). Next, push the
canopy (2a) to the mounting plate (1c) and use the screws
(2b). This will secure the canopy to the mounting plate.
You have now completed the installation of your fixture,
enjoy.
1e.
1c.
2b.
1d.
1e.
2c.