Installation Guide

GND

2a.

2c.

illustration 01

1b.

1a.

*DC driver larger than illustration

19054 28th Avenue Surrey, BC Canada V3S 6M3

T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196

W: kuzcolighting.com

20181107

Select the hanging height and install 4-inch threaded

rod (2e) in-between the fixed swivel (2d) and the extension

rods (2c), feed the wire and cable starting from bottom

through each rod until you reach the fixed swivel

connector. Once the rods are fully connected and the

wires are pulled into the canopy (2a), using a wrench to

secure, connect the wires to the DC driver using the

marrettes provided, negative to negative and positive to

positive (refer to the diagram on the driver). Repeat the

step for the second driver. (Ensure the line voltage

power lines are connected to the line voltage side of

each driver - L to live and N to neutral). Connect all wires

(1b) correctly L live wire (black to black) N neutral wire

(white to white) and G ground to ground with provided

marrettes. Tighten the locking screw with allen key, then

attach the aircraft cable (illustration01) to a suitable

supporting member in the ceiling.

2e.

Detailed illustration: