Installation Guide

INSTALLATION SHEET
PD82536
Ceiling LED Pendant
START FROM HERE
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20191113
Please Note:
• This Kuzco LED fixtures come with pre-wired LED module(s)
• Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary
contact with the module could cause permanent damage
• Use ELV (Electronic Low Voltage) or TRIAC type of dimmer for dimming application
• Make sure POWER is COMPLETELY OFF at the fuse box
• Have your fixture installed by a qualified licensed electrician
• Prepare everything in a clear area
• Wear gloves at all time during this installation
• Read instructions carefully before you start assembly
• Keep this installation sheet for future reference
Technical Support: 1-855-855-8926
1. Remove fixture from its original package
2. Separate mounting plate (1c) from canopy (2a) by
removing canopy screws (2f)
3. Attach mounting plate (1c) to electrical junction box (1a)
using screws provided (1e) in hardware package
4. Determine hanging height of fixture by securing rods (2d)
5. Secure mounting plate (1c) to mounting surface with
anchors (1f) and screws (1h)
6. Make proper electrical connections (black to hot “L”, white
to neutral “N”, ground to “GND”) with wire nuts (1b)
provided in hardware package
7. Attach canopy (2a) to mounting plate (1c) with canopy
screws (2f)
2d.
1a.
2a.
1b.
1c.
1e.
2f.
1f.
1h.