SatelliteTelevision owner's manual TracVision G4

6. Remove and save the three screws securing the

radome to the baseplate. Carefully lift the radome

straight up until clear of the antenna assembly and

set it aside in a safe place. If you bring the radome

topside, be sure to secure it with a lanyard so that

it does not fall overboard.

7. Remove the foam shipping restraint from the

antenna unit.

8. Using a 10 mm wrench, remove the two azimuth

shipping restraint bolts, washers, and spacers from

the antenna unit, as shown in Figure 2-4.

9. Place the foam seal in position on the mounting

surface with the hole centered over the cable

access cutout. Do not remove the paper backing at

this time. Align the seal with the vessel’s centerline

and the narrow end pointing toward the bow (see

Figure 2-5). Scribe a line all around the seal.

54-0147

TracVision G4 Technical Manual

Figure 2-5

Baseplate/Foam Seal Orientation

(Bottom View)

Bow

RF1

RF2

Data

Power

Foam Seal

Figure 2-4

Azimuth Shipping

Restraint Removal

Washer

Spacer

Bolt

The shipping restraints must be

removed before power is applied.

Save the restraints for reuse and be

sure to install them whenever the

antenna unit is moved from place to

place. See

Section 5.10, “Preparing

for Shipment” on page 118

for

instructions on preparing for

shipment.