SatelliteTelevision owner's manual TracVision G4

Option 2 - Flush-mounting

1. Choose a location based upon the guidelines in

“Choosing the Best Location for the ADCU” on

page 14.

2. A template has been provided in Appendix C on

page 129 as a guide to mark and cut the proper

hole for the flush mount bracket. Cut the hole and

make certain the bracket and ADCU will fit easily.

3. Attach the flush mount bracket to the ADCU by

loosening the two screws on the underside of the

ADCU. Slide the flush mount bracket backward

over the ADCU until the two notches meet the

screws as shown in Figure 2-17.

4. Tighten the screws to secure the ADCU to the

bracket.

5. After completing the wiring described in

Section 2.6, “Wiring the ADCU,” insert the ADCU

and bracket into the hole and secure the unit to the

mounting surface with the #8 (black) screws and

#8 washers supplied in the kitpack.

Installation

54-0147

Figure 2-17

Securing the ADCU to the

Flush Mount Bracket