Cell Phone User Guide

16 Making and Answering Calls
1. Select Menu → Settings → Network →
Digital/Analog.
2. Select an option and press .
–
Automatic automatically switches the
phone between digital and analog.
–
Analog only sets the phone to work in
analog mode only.
–
Analog call forces a call into analog mode
for the duration of the next call.
– Digital only sets the phone to work in
digital mode only.
Setting an alert for roaming
You may use this setting if you want the phone to
alert you when you roam outside of your home
service area.
1. Select Menu → Settings → Network →
Roam/Svc Alert.
2. Select an option and press .
–
When no svc alerts you with three tones
decreasing in pitch when service is lost
and three tones increasing in pitch when
service is acquired again.
–
On roam change alerts you with two
decreasing tones when roaming service is
acquired and three increasing tones when
home area service is acquired again.
–
On any change alerts you with three
increasing tones if there is a change in
roaming service or three decreasing tones
if the phone loses service.
Setting the roam ringer
You can set a ringer to indicate when an incoming
call will be subject to roaming charges.
• Select
Menu → Settings → Sounds →
Roam Ringer → Enabled.
Setting Call Guard
You can set the phone to warn you before you
answer or place a call while roaming.
• Select
Menu → Settings → Convenience →
Call Guard → Call Prompt.
– The phone now emits a distinctive roam
ring to indicate when you are roaming
during calls.
– To accept or place a call while roaming,
you must press .
Note: Call Prompt is disabled when the phone is
in Emergency Mode.
82-N8735-1.book Page 16 Thursday, October 27, 2005 12:37 PM