Operation Manual

2-18
2
Basic Operations
If the driver software is not installed successfully, the PC will be unable to recognize the
camera. If this occurs, use the procedure below to uninstall the drivers. Then use the
procedure on p.2-12 to re-install the drivers.
* Note that this procedure is only required for Windows 98 and Windows 98SE.
Uninstalling the driver software
(Windows 98 and Windows 98SE only)
1 Load the memory card into the camera. ( p.1-3)
2 Connect the AC adapter to the camera.
3 Connect the camera to your PC using the dedicated USB cable
and then start up the PC.
4 Press the POWER button
H
to switch the camera on.
5 Right-click [My Computer] and
select [Properties].
6 When the System Properties
window opens, click the [Device
Manager] tab.
Finecam_E.book Page 18 Thursday, August 28, 2003 6:21 PM