User guide

d) After 30 ± 3 minutes of topping time the green READY LED will light and the

yellow CHARGING light will extinguish. Note the elapsed time. The indicated

voltage will drop towards 25.2 Volts over a few seconds (time set by the

capacitor and resistor choice).

e) As the indicated voltage drops below 25.2 Volts, the yellow CHARGING LED will

again light and the green READY LED will extinguish. Immediately begin timing

the second topping duration.

f) After 15 ± 1.5 minutes the second topping charge will complete, the green

READY light will illuminate, and the yellow CHARGING LED will extinguish.

Note the elapsed time. Again, the indicated voltage will drop towards 25.2 Volts.

g) As the indicated voltage drops below 25.2 Volts, the yellow CHARGING LED will

again light and the green READY LED will extinguish. Immediately begin timing

the third topping duration.

h) After 2 minutes ± 15 seconds the third topping charge will time out, the green

READY light will light and the yellow CHARGING light will extinguish. Note the

elapsed time.

i) The Activator 282 will repeat this cycle with two minute topping charges

indefinitely, until AC power is removed.

7.0 ROUTINE MAINTENANCE

There are only three items that require routine maintenance:

a) Fan – Keep clean and free of dust or debris. Use low pressure air or vacuum

cleaner. Check air vent holes. Vacuum clean if necessary.

b) Connections – Check that the quick disconnect contacts are tight and free of

corrosion. Use approved contact cleaner. Check movement of the quick –

disconnect knob – clean and lubricate if necessary. Do not get lubricate on

the contacts or inside the unit.