User guide

Activator Outline

ACTIVATOR 282

BATTERY CHARGER FOR 24 VOLT AIRCRAFT AND MILITARY BATTERIES

0.1 QUICK INSTRUCTIONS

CAUTION: Read the complete instructions before use. These quick instructions

are for reference only.

A. Set switch of ‘Off’: Select Lead Acid or NiCad.

B. Plug in AC line, 90-240V 50/60/400 Hz. Connect Activator to battery via

Quick-Connect knob.

C. Switch to on. Digital Voltmeter reads charge voltage.

 CHARGING LED on. Voltage begins to rise.

 If battery voltage is below ~ 10V, OVERTEMP/FAULT LED will pulse. As

battery voltages raises, OVERTEMP/FAULT LED will remain steady.

D. When the battery is charged, yellow CHARGING LED is off, READY LED on.

E. After 10 hours of charging, if the battery voltage remains under 28 Volts and

voltage does not continue to rise (even very slowly), or if the voltage lowers

instead of rising, the OVERTEMP/FAULT LED will blink and charge will cut

off. This may be a battery fault or the battery requires more time to charge.

Reset rocker switch to ‘Off’ then back to ‘On’ for further charge. If this

requires many reset cycles, battery may not be accepting charge.

F. If battery overheats, charge cuts off and OVERTEMP/FAULT LED is on.