Electrical Schematic

PAGE 3
LANCASTER HYDRO-FORCE™
4” ENCAPSULATED SUBMERSIBLE MOTORS
SINGLE PHASE TWO-WIRE & THREE-WIRE, ½ -1 HP, 230 V
EQUIPPED WITH LIGHTNING ARRESTORS
TECHNICAL FEATURES
Two-Wire Design
• Split-phase induction run (IR) design with built-in electronic starter connected in series to a high resistance
auxiliary start winding – no capacitor required – electronic starter controls disengagement of start winding as a
function of starting time and starting voltage.
Three-Wire Design
• Capacitor-start induction run (CSIR) design – control box required –
ᵒ Control box quick-disconnect design disconnects control box components from the electrical system when the
lidisremoved–willretrotF.E.Q-DcontrolboxesofsameHPandvoltage.
ᵒ Control box components include a 230V voltage relay for easy installation, two ground terminals, cable
terminals up to AWG 8, and a start capacitor for higher starting torque.
ᵒ Control box painted steel enclosure with multiple knockouts is rated NEMA 3R for indoor or outdoor
installation.
Two-Wire and Three-Wire Designs
• Statorlledwithspecialepoxyresinandhermeticallysealedforabetterinsulationofthewindingandagreater
heat exchange.
• Rotor and thrust bearings lubricated by water mixed with Propylene Glycol.
• Built-in check valve for restoring of cooling liquid (well water) as needed.
• Built-in lightning arrestors providing surge protection.
• Built-in automatic reset overload providing thermal (overheat) protection caused by high amperage and/or
inadequate motor cooling.
• AISI 304 Stainless Steel motor frame shell, stator ends and stator liner, hermetically sealed for maximum
corrosion resistance.
• AISI 303 Stainless Steel splined shaft end.
• Cationic epoxy electrocoated G20 cast iron top and bottom end brackets.
• AISI 304 Stainless Steel top and bottom end bracket covers.
• Shaft sealing system using labyrinth seal, sand slinger and lip seal.
• Pressure equalizing diaphragm.
• 4”NEMAange.
• M8 threaded mounting studs.
• Removable plug-in lead cable.
• Degree of protection: IP68.
• Insulation: Class B.
• Time Rating: Continuous Duty.
• UL recognized component.
OPERATING LIMITS
• Water temperature: max. 95°F (35°C).
• Maximum starts per hour: 30.
• Minimumowratespeedformotorcoolinginwaterupto95°F:0.26ft/s(0.08m/s).
• Voltage tolerance: two-wire design +/-10%, three-wire design +6%/-10%.
• Maximum submergence depth: 492 ft (150m).
• Mounting position: vertical/horizontal.
• NEMA service factors (S.F.) for 60 Hz pump motors.
• Axial Thrust Load: 300 Lb (1500 N).