Network Router User Manual

9: Setup Mode: Advanced Settings
XPress DR+ User Guide 67
Default Settings (Option 7)
Select 7 to reset the unit’s channel configuration, email settings, and expert settings to
the default settings. The server configuration settings for IP address, gateway IP address,
and netmask remain unchanged. The configurable pins’ settings also remain unchanged.
The specific settings that this option changes are listed below.
Channel 1 and Channel 2 Configuration Defaults
Baudrate
9600
I/F Mode
4C (1 stop bit, no parity, 8 bit, RS-232C)
Own TCP port number
Channel 1: 10001
Channel 2: 10002
Connect Mode
C0 (always accept incoming connection; no active
connection startup)
Hostlist retry counter
3
Hostlist retry timeout
250 (msec)
Start character for serial channel 1
0x0D (CR)
All other parameters
0
Expert Settings Defaults
TCP Keepalive time in s
45
ARP Cache timeout in s
600
Disable Monitor Mode @ bootup
No
HTTP Port Number
(1-65535)
80
MTU Size (512 – 1400)
0 (resulting in an operational value of 1400)
Enable alternate MAC
No ( for OEM use only)
Ethernet Connection Type
0 (auto-negotiate)
Security Settings Defaults
Disable SNMP
No
SNMP community name
public
Disable Telnet setup
No
Disable TFTP Firmware Update
No
Disable Port 77FEh
No
Disable Web Server
No
Disable Web Setup
No
Disable ECHO ports
Yes
Enable Enhanced password
No