Network Router User Manual

11: Monitor Mode
XPress DR+ User Guide 72
Table 11-1. Monitor Mode Commands
Command Command Name Function
VS x.x.x.x
Version Queries software header record (16 bytes) of unit
with IP address x.x.x.x.
GC x.x.x.x
Get Configuration Gets configuration of unit with IP address x.x.x.x as
hex records (120 bytes).
SC x.x.x.x
Send Configuration Sets configuration of unit with IP address x.x.x.x
from hex records.
PI x.x.x.x
Ping Pings unit with IP address x.x.x.x to check device
status.
AT
ARP Table Shows the unit’s ARP table entries.
TT
TCP Connection
Table
Shows all incoming and outgoing TCP connections.
NC
Network Connection Shows the unit’s IP configuration.
RS
Reset Resets the unit’s power.
QU
Quit Exits diagnostics mode.
G0, G1, ....,Ge, Gf
Get configuration
from memory page
Gets a memory page of configuration information
from the device.
S0, S1,...,Se, Sf
Set configuration to
memory page
Sets a memory page of configuration information
on the device.
GM
Get MAC address Shows the unit's 6-byte MAC address.
SS
Set Security record Sets the Security record without the encryption key
and length parameters. The entire record must still
be written, but the encryption-specific bytes do not
need to be provided (they can be null since they
are not overwritten).
Responses to some of the commands are in Intel Hex format.
Note: Entering any of the commands listed above generates one of the following
command response codes:
Table 7-2. Command Response Codes
Response Meaning
0> OK; no error
1> No answer from remote device
2> Cannot reach remote device or no answer
8> Wrong parameter(s)
9> Invalid command