User's Manual

3: Operations
SLP: set sntp primary 204.152.184.72<Enter>
The following command sets the secondary SNTP server address to
cuckoo.nevada.edu:
SLP: set sntp secondary
cuckoo.nevada.edu<Enter>
Setting the local GMT offset
The Set SNTP GMT offset command is used to set the offset from GMT for the
date/time returned by SNTP. The offset can be configured in whole hours between -
12 and 12 hours.
Note: The SLP does not support automatic adjustment for daylight savings.
To set the local GMT offset:
1. At the command prompt, type set sntp gmtoffset, followed by the offset
value and press Enter.
Example
The following command sets the local GMT offset to -12:
SLP: set sntp gmtoffset -12<Enter>
Displaying SNTP configuration information
The Show SNTP command displays all SNTP configuration information.
To display SNTP configuration information:
1. At the command prompt, type show sntp and press Enter.
Example
The following command displays the SNTP configuration information:
SLP: show sntp<Enter>
Date/Time (Local GMT Offset -12): 2006-02-21 21:32:48
Primary Host: 204.152.184.72
Secondary Host: cuckoo.nevada.edu
Displaying network configuration information
The Show Network command displays TCP/IP, Telnet, SSH, Web, SSL and SNMP
configuration information.
IP address, subnet mask and gateway
Enabled-disabled status of Telnet, SSH, HTTP,SSL and SNMP support
Telnet, SSH, and HTTP port numbers
HTTP authentication method and SSL access setting
Network status
See 4:Advanced Operations for more information on SNMP
To display network configuration information:
SecureLinx SLP Remote Power Manager 60