User's Manual

4: Advanced Operations
TACACS+ Command Summary
Command Description
Set Authorder Specifies the authentication order for each new session attempt
Set TACACS Enables/disables SSL support
Set TACACS Host Sets the IP address or hostname of the TACACS server
Set TACACS Key Sets the TACACS encryption key
Set TACACS Port Sets the TACACS server port number
Show TACACS Displays TACACS configurations
Add GrouptoTACACS Grants a TACACS account access to one or more groups
Add OutlettoTACACS Grants a TACACS account access to one or all outlets
Add PorttoTACACS Grants a TACACS account access to one or serial ports
Delete GroupfromTACACS Removes access to one or more groups for a TACACS account
Delete OutlettoTACACS Removes access to one or more outlets for a TACACS account
Delete PortfromTACACS Removes access to one or more serial ports for a TACACS account
Set TacPriv Access Sets the access level for a TACACS account
Set TacPriv Envmon Grants or removes privileges to view input and environmental monitoring status
List TacPrivs Displays access levels for all TACACS accounts
List TacPriv Displays all accessible outlet/groups/ports for a TACACS account
Enabling and Setting up TACACS+ Support
There are a few configuration requirements for properly enabling and setting up
TACACS+ support. Below is an overview of the minimum requirements:
1. Enable TACACS+ support.
2. Define the IP address and domain component of at least one TACACS+server.
3. Set the TACACS+ key configured on the supporting TACACS+server.
Enabling and disabling TACACS+ support:
The Set TACACS command is used to enable or disable TACACS+ support.
To enable or disable TACACS+ support:
At the SLP: prompt, type set tacacs, followed by enabled or disabled and press
Enter.
Setting the TACACS+ server address:
The Set TACACS Host command sets the IP address or hostname of the TACACS+
server.
To set the TACACS+ server address:
At the SLP: prompt, type set tacacs, followed by host1 or host2 and the TACACS+
server’s IP address or hostname. Press Enter.
Examples
The following command sets the primary TACACS+ server address to 98.76.54.32:
SLP: set tacacs host1 98.76.54.32<Enter>
SecureLinx SLP Remote Power Manager 87