User's Manual

5: Commands and Levels
EDS-MD Command Reference 47
connect (tunnel-connect:8)
host 1 (tunnel-connect-host:8:1)
host 2 (tunnel-connect-host:8:2)
host 3 (tunnel-connect-host:8:3)
host 4 (tunnel-connect-host:8:4)
host 5 (tunnel-connect-host:8:5)
host 6 (tunnel-connect-host:8:6)
host 7 (tunnel-connect-host:8:7)
host 8 (tunnel-connect-host:8:8)
host 9 (tunnel-connect-host:8:9)
host 10 (tunnel-connect-host:8:10)
host 11 (tunnel-connect-host:8:11)
host 12 (tunnel-connect-host:8:12)
host 13 (tunnel-connect-host:8:13)
host 14 (tunnel-connect-host:8:14)
host 15 (tunnel-connect-host:8:15)
host 16 (tunnel-connect-host:8:16)
disconnect (tunnel-disconnect:8)
modem (tunnel-modem:8)
packing (tunnel-packing:8)
serial (tunnel-serial:8)
xml (xml)
Table 5-1 Commands and Levels
accept (tunnel-accept:8) level commands
accept mode always
Enables the tunneling server to always accept tunneling con-
nections.
accept mode any character
Enables the tunneling server to accept tunneling connections
only when a
character is received through the corresponding line (serial
port).
accept mode disable
Disables accept mode tunneling.
accept mode modem control asserted
Enables the tunneling server to accept tunneling connections
when the modem
control pin is asserted.
accept mode modem emulation
Enables modem emulation for accept mode tunneling.
accept mode start character
Enables accept mode tunneling when the configured start cha-
racter
is received on the line.
aes decrypt key <hexadecimal>
Sets the accept tunnel AES decrypt key with up to 16 bytes.
Each byte is represented by two adjacent hex digits.
Bytes may run together or be separated by optional punctua-
tion:
123ABC "12 3A BC" 12,3A,BC 12.3a.bc 12:3a:bc
Note that quotes must enclose the value if it contains spaces.
aes decrypt key text <text>
Sets the accept tunnel AES decrypt key with up to 16 bytes.
Each byte is represented by a single character.