User's Manual

5: Commands and Levels
EDS-MD Command Reference 74
flush serial enable
Flushes the serial data buffer upon establishing a connect
mode tunneling
connection.
flush start character disable
Enables forwarding of the connect start character into the net-
work.
flush start character enable
Disables forwarding of the connect start character into the
network.
host <instance>
Enters the next lower level.
Specify the instance for the next lower level.
host mode sequential
Connects to the first host in the list that accepts the connec-
tion.
host mode simultaneous
Selects simultaneous connections to all hosts on the host list.
kill connection
Disconnects the active connect mode tunneling connection or
connections.
local port <number>
Sets a specific port for use as the local port.
<number> = the number of the port to use.
no email connect
Discontinues sending email alerts upon establishing a connect
mode tunnel.
no email disconnect
Discontinues sending email alerts upon closing a connect mode
tunnel.
promote host <number>
Promotes the identified host, exchanging it place with the host
above it,
to adjust the order of the defined hosts.
reconnect time <milliseconds>
Sets the reconnect time value for tunneling connections estab-
lished by the
device in milliseconds.
<milliseconds> = timeout in milliseconds.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the current CLI
session.
show status
Displays tunnel connect status.
start character <control>
Sets the connect mode start character.
The character may be input as text, control, decimal, or hex.
A control character has the form <control>C.
A decimal value character has the form \99.
A hex value character has the form 0xFF.
write
Stores the current configuration in permanent memory.
connect (tunnel-connect:2) level commands
block network disable
Forwards (tunnels) network data in connect mode tunneling.
block network enable
Discards all data coming in from the connect mode tunnel be-
fore forwarding
it to the serial interface (generally used for debugging).
block serial disable
Forwards (tunnels) serial data in connect mode tunneling.
block serial enable
Discards all data coming in from the serial interface before
forwarding
it to the connect mode tunnel (generally used for debugging).
clrscrn
Clears the screen.
connect mode always
Enables the tunneling server to always establish tunneling con-
nections.
connect mode any character
Enables the tunneling server to establish a tunneling connec-
tion when a
character is received on the corresponding line (serial port).