Installation & Assembly

8ASSEMBLY INSTRUCTIONS

NOTE: Please consult a qualified electrician if you are not certain of installation or servicing.

CAUTION: Before starting installation or servicing, disconnect power by turning off the circuit breaker or by

removing the fuse at the fuse box.

1. Carefully unpack the fixture, lay out all parts on a clean surface.

2. Adjust Decorative Arms to their proper position.

3. Secure the following parts to the body as below: nipple, tube, covers, nut and loop.

4. Fasten the Mounting Bracket to Outlet Box using the provided Outlet Box Machine Screws.

5. Using two pliers, twist open links at the two ends of the Chain. Hook one link to the Loop and the other link

to the Top Finial Loop. Close the links. Place a piece of cloth between the plier’s jaws and the chain links to

prevent scratching the link finish.

6. Weave the fixture wires up through the Loop, through the Chain, through the Top Finial Nut, through the

Canopy, through the Top Finial Loop and through the Threaded Stem on the Mounting Bracket.

7. Connect the wire with writing on it from the fixture to the black wire (live wire) from the supply circuit.

Connect the wire without writing on it (with raised ribs) from the fixture to the white wire (neutral wire)

from the supply circuit. Cover the connections using provided wire connectors. Tie ground wires from fixture

and from Outlet Box to the Ground Screw on the Mounting Bracket. Position wires back inside Outlet Box.

8. Place the Canopy over the nipple all the way to the Ceiling and tighten the collar loop to the threaded ring

onto the Canopy until the Canopy is held firmly against the ceiling.

9. Fasten the nipple into the body. Place the following parts through the nipple as follows: metal washer, glass,

washer, cover and finial. Install bulbs (not included).

10. Turn the power on.

PAGE 1
8ASSEMBLY INSTRUCTIONS NOTE: Please consult a qualified electrician if you are not certain of installation or servicing. CAUTION: Before starting installation or servicing, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box. 1. Carefully unpack the fixture, lay out all parts on a clean surface. 2. Adjust Decorative Arms to their proper position. 3. Secure the following parts to the body as below: nipple, tube, covers, nut and loop. 4.
PAGE 2
INSTRUCCIONES DE ENSAMBLADO NOTA: Por favor, consulte con un electricista calificado en caso de que no esté seguro de la instalación o el mantenimiento. CAUCIÓN: Antes de comenzar la instalación o mantenimiento, desconectar la electricidad apagando el cortacircuitos o quitando el fusible la caja de fusibles 1. Desempacar cuidadosamente la lámpara, arreglar todas las piezas sobre una superficie limpia. 2. Ajuste los brazos decorativos a sus posiciones adecuadas como se muestra. 3.
PAGE 3
9 . Fixez le raccord et le tube dans le boîtier. Mettez les pièces suivantes dans le raccord de la façon montrée ci-après : rondelle métallique, lampe en verre, rondelle, couvercle et faîteau. Posez les ampoules (non comprises). 10 . Mettre sous tension.