Installation Manual

Larson Electronics LLC www.LarsonElectronics.com [e-mail]
9419 E US HWY 175, Kemp, TX 75143 - P: [phone] - F: [phone]
EXP-EXT-3W
IMPORTANT – SAVE THESE INSTRUCTIONS
When using electrical equipment, basic safety precautions should always be followed including the
following:
DANGER: Do not install or service unless area is known to be non-hazardous. The Exit Sign has more
than one power supply connection.
WARNING: Electrical power must be turned off before and during installation and maintenance.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
 This fixture should be installed in strict accordance with the National Electrical Code and any
local requirements.
 This fixture should be mounted in locations and at heights where it will not readily be subjected
to tampering by unauthorized personnel.
 To prevent ignition of hazardous atmospheres, disconnect fixture from the supply circuit before
opening. Keep tightly closed when in operation. When AC power is disconnected, the battery
power will be live.
 To reduce risk of fire or explosion, do not install where the marked operating temperature
exceeds the ignition temperatures of the hazardous atmosphere(s).
 Do not mount near gas or electric heaters.
 Do not let power supply cords touch hot surfaces.
 Do not attempt to service the battery inside this fixture. This fixture incorporates a sealed, no
maintenance battery that is not field replaceable.
 The use of accessory equipment not recommended by the manufacturer may cause an unsafe
condition.
 Do not use this equipment for other than intended use.
 Installation and servicing of this fixture should be performed by qualified personnel.
TYPICAL INSTALLATIONS
These fixtures are provided with 1/2" NPT hubs.