Installation & Assembly

1
Installation Instructions
1
2
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
3
4
1.0
LAMP
SOCKET
SHADE BASE
FIXTURE ARM
SHADE
SOCKET ASSEMBLY
5
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliant junctionNEC
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED LEDlamps may be dimmed with a dimmer. Consult lamp manufacturer for
additional information.
This instruction shows a typical installation.
1A
6
7
THUMB SCREW
HUB STUD
HEX NUT &
WASHER
FIXTURE ARM
HUB
1
3
6
8
7
2
8
FIXTURE LOOP
WASHER
HUB COVER
THREADED NIPPLE
Chandeliers
Install the fixture arms onto the hub studs using the washers and hex nuts.
Install the fixture arms to the bottom of the socket assembly using the thumbscrews.
Feed the fixture wires through the threaded nipple, hub cover, washer, and fixtureloop (in that order), then screw the
threaded nipple onto the hub.
Place the hub cover and washer onto the threaded pipe and secure them in placeby screwing the fixture loop onto the
pipe. Skip to step 6.
Feed the fixture wires through the fixture loop and screw it onto the hub.
Follow enclosed supplement installation instructions for electrical and fixture installation onto house outlet box.
Install the shade by placing it into the shade base. Repeat for remaining shades.
Screw the lamps into the sockets. Refer to the label on the socket for Max Wattage Information.