Full Product Manual

www.LaViewUSA.com www.LaViewUSA.com24 25
Checkup of Export Result using USB Flash Drive
Checkup of Export Result using USB Writer
Conguring General
Network Settings
Purpose:
Network settings must be properly congured
before you operate NVR over network.
Steps:
1. Enter the Network Sengs interface.
Menu >Conguraon>Network
2. Select the General tab.
Network Settings Interface
3. In the General Settings interface, you
can congure the following settings: NIC
Type, IPv4 Address, IPv4 Gateway, MTU
and DNS Server.
If the DHCP server is available, you can
check the checkbox next to DHCP to
automatically obtain an IP address and
other network settings from that server.
Note: For the LV-N9808C8E series NVR,
you need to congure the internal NIC
address, so that IP addresses are assigned
to the cameras connected to the PoE or
built-in switch interfaces.
Note: The valid value range of MTU is 500
~ 9676.
4. After conguring the general settings,
click Apply to save the settings.
Conguring advanceed
Settings
Conguring DDNS
Purpose:
If your NVR is set to use PPPoE as its default
network connection, you may set Dynamic DNS
(DDNS) to be used for network access.
Prior registration with your ISP is required before
conguring the system to use DDNS.
Steps:
1. Enter the Network Settings interface.
Menu >Conguraon> Network
2. Select the DDNS tab to enter the DDNS
Settings interface.
DDNS Settings Interface
3. Check the DDNS checkbox to enable this
feature.
4. Select DDNS Type. Five different DDNS
types are selectable: IPServer, DynDNS,
PeanutHull, NO-IP and HiDDNS.
Conguring NTP Server
Purpose:
A Network Time Protocol (NTP) Server can be
congured on your NVR to ensure the accuracy of
system date/time.
Steps:
1. Enter the Network Settings interface.
Menu >Conguraon> Network
2. Select the NTP tab to enter the NTP
Settings interface.
NTP Settings Interface
3. Check the Enable NTP checkbox to
enable this feature.
4. Congure the following NTP settings:
• Interval: Time between the two
synchronizing actions with NTP
server. The unit of time is in
minutes.
• NTP Server: IP address of NTP
server.
• NTP Port: Port of NTP server.
5. Click the Apply button to save settings
and exit the interface.
Note: The me synchronizaon interval can
be set from 1 to 10,080 min, and the default