Full Product Manual

ASSEMBLY

Ensure that the knob is fully tightened before operating the tool; check it periodically for tightness

during use to avoid serious personal injury.

To remove the shaft:

■ Stop the engine and remove the battery pack.

■ Loosen the knob.

■ Push in the button and twist the shafts to remove and separate ends.

Fig. 5 Fig. 6

Fig. 7 Fig. 8

Battery Release Button

INSTALLING AND REMOVING THE SHAFT (See Figs. 7-8)

To install the battery pack:

■ Align the battery pack with the battery slot.

■ Insert the battery pack into the battery slot until the battery pack secures into place. Make sure

the battery inserted in the correct direction (Fig. 7).

■ Do not use force when inserting the battery pack. It should slide into position and "click".

To remove the battery pack:

■ Locate the battery release button, press and hold the button up (Fig. 8).

■ Slide the battery pack off the battery slot.

WRONG

Tight

Button

Positioning Hole

Loosen

NOTE: If the button does not release completely in the positioning hole, the shafts are not locked

into place. Slightly rotate from side to side until the button is locked into place.

■ Secure the shafts tight using the knob by turning it clockwise (Fig. 6).