Full Product Manual

CHARGER LEDS

■ If the battery is not connected to the charger, a continuous green LED light indicates that the

plug is plugged into an outlet socket and the battery charger is ready for operation.

■ Charging: a continuous red LED on the charger indicates that the battery is charging normally.

■ Charged: a continuous green LED on the charger indicates that the battery is ready for use.

■ After continuous or repeated charging cycles without interruption, the charger may warm up.

This is normal and does not indicate a technical defect of the battery charger.

CHARGING THE BATTERY PACK (See Figs. 11-12)

■ Insert the charging connector into the charging port on the battery (Fig. 11).

■ Connect the charger to the power supply.

■ Allow sufficient charging time (see Product Specifications), and then disconnect the charger from

the power supply.

■ Remove the charging connector from the charging port (Fig. 12).

BATTERY PACK AND CHARGER

INDICATOR LIGHTS

STATUS

Green, continuous

Fully charged / Connected to

power supply (Standby)

Red, continuous Charging

If any part of the charger is missing or damaged, do not operate it! Replace the charger with a new

one. Failure to heed this warning could result in possible serious injury. Check the voltage! The

voltage must comply with the information on the rating label.

NOTE: It is normal for the battery pack and the charger to become warm (but not hot) during the

charging process. If the battery does not charge properly, check to make sure the electrical outlet

is operational. Always charge the battery before storage!

Fig. 11 Fig. 12