Full Product Manual

OPERATION

Fig. 15

Fig. 16 Fig. 17

START

Fig. 18 Fig. 19

STARTING AND STOPPING THE GRASS TRIMMER (See Figs. 15-20)

For cold start:

■ Make sure that the battery pack is securely in place.

■ Place the trimmer on a levelled surface, outdoors.

■ Press the primer bulb 5 times.

■ Turn the choke lever to the CHOKE position (Fig. 15).

■ Lift the start button cover and press the start button

until the engine starts. Then immediately engage the

throttle safety and the throttle trigger to start the

trimmer (Fig. 16-19). The choke lever will

automatically switch to RUN position.

■ If the choke lever is left on choke, the grass trimmer will stop running in 3-5 seconds.

NOTE: If the engine does not start, repeat step 5 until the engine starts.

■ If the trimmer fails to start, check the Troubleshooting section in the manual.

NOTE: This 2-cycle grass trimmer is equipped with an automatic choke reset. The user must

switch the choke lever to CHOKE position for cold starts. As soon as the throttle trigger is

engaged, the choke lever will automatically switch to the RUN position.

NOTE: After the engine starts and runs, release the throttle trigger and allow the trimmer to warm

up at idle for several minutes.

RUN

CHOKE

For warm start:

■ Make sure that the battery pack is securely in place.

■ Place the trimmer on a levelled surface, outdoors.

■ Press the primer bulb 5 times.

■ Make sure the choke lever in the RUN position.