Full Product Manual

ManualsBrandsLawnmaster ManualsGas String Trimmers26cc Gas NO-PULL Electric Push Button Start 2-Cycle String Trimmer

TROUBLESHOOTING

Before proceeding, shut off the engine, wait for all moving parts to stop, and remove the battery pack.

Failure to follow these instructions can result in serious personal injury or property damage.

If your grass trimmer does not appear to operate properly, follow the instructions below. If this does

not solve the problem, please contact your local repair agent.

PROBLEM POSSIBLE CAUSE SOLUTION

The engine

does not

start.

The engine

does not

reach full

speed and

emits

excessive

smoke.

No spark.

No fuel.

The engine is flooded.

Incorrect lubricant/fuel

mixture.

Clean or replace the spark plug. Reset the spark plug

gap. Refer to the Spark Plug Replacement section in

this manual.

The battery is not

inserted.

Insert the battery correctly. Ensure the battery is fully

charged.

Check that there is sufficient fuel in the fuel tank. Push

the primer bulb until the bulb is full of fuel. If the bulb

does not fill, the primary fuel delivery system is

blocked. Contact an authorized service dealer. If the

primer bulb fills, the engine may be flooded, proceed

to the next item.

The air filter is blocked.

Clean the air filter. Refer to Cleaning the Air Filter

section in this manual.

Remove the spark plug referring to the Spark Plug

Replacement section in this manual. Press the start

button 5 to 10 times. Then place the trimmer still with

the spark plug removed for about 30 minutes. After

30 minutes, replace the spark plug referring to the

Spark Plug Replacement section. Then re-start the

engine. If the engine still does not start, contact an

authorized service dealer.

Use fresh fuel and the correct 2-cycle lubricant mix

(40:1).

The air filter is dirty.

Clean the air filter. Refer to Cleaning the Air Filter

section in this manual.

The spark plug is worn

out.

Clean or replace the spark plug. Reset the spark plug

gap. Refer to the Spark Plug Replacement section in

this manual.

The engine overheats.

Allow the engine to run at idle for 5 minutes. Then

stop the trimmer and allow it to cool for about 20

minutes.