User Manual

5
leakSMART
®
PRO
Valve Setup and Operation
1. Download leakSMART
®
app via google play store (Android) or iTunes (IOS).
Pair your leakSMART
®
valve with your smart home system (Smart hub
required)
• Place your leakSMART
®
Valve near your installation location, so you
can verify that it is within range of your smart home leakSMART
™
Hub.
Verification will be done in pairing mode in APP.
• Connect leakSMART
®
Valve to the provided 9V Power Supply and verify
that the AC power cord is long enough to reach the valve installation
location. (An optional 9 ft. AC power adapter extension wire is also
available. This, and other leakSMART
®
accessories, can be purchased at
leakSMART
®
.com) It is recommended to install 4 AA alkaline batteries
(provided) as a source of battery backup. ( A flashing blue light on the
front of the unit will indicate that it’s ready to pair. If the blue light stops
flashing, press the center button 5 times quickly to reset pairing mode.
Now, open the leakSMART
®
App on your smart device.
 On the leakSMART
®
hub, press the blue button once to enter pairing
mode, or use the add device tab found on the home page of the
leakSMART
®
app. As a reminder, a steady-single green flashing light
on the leakSMART
®
Hub indicates pairing mode and will last 3 minutes
while in pairing mode.
CAUTION: Do not replace the 4 AA battery block with a 9v battery, this could damage the
device and void warranty.