Manualshelf

Manual

ManualsBrandsLEESON ManualsSoftwareSM Series Sub-Micro Inverters
31323334353637383940
33
P11 TB-13B FUNCTION SELECT
This selects the function of terminal TB-13B. Closing TB-13B to TB-11 (or opening in the case of
setting 09 and 11) activates the selected function. The following functions can be selected:
01 NONE: Disables the TB-13B function.
02 0-10 VDC: Selects a 0-10 VDC signal (at TB-5) as the AUTO speed reference input.
03 4-20 mA: Selects a 4-20 mA signal (at TB-25) as the AUTO speed reference input.
04 PRESET SPEED #2: Selects PRESET SPEED #2 as the AUTO speed reference. The drive will
operate at the frequency programmed into Parameter 32.
05 DECREASE FREQUENCY: Closing TB-13B to TB-11 will decrease the speed setpoint until
the contact is opened. TB-13E must be programmed for INCREASE FREQ.
06 START FORWARD: Sets up the drive for a 3-wire start/stop circuit. Momentarily close TB-13B
to TB-11 to start the drive, and momentarily open TB-1 to TB-11 to stop.
07 JOG FORWARD: Close TB-13B to TB-11 to JOG in the forward direction. The drive will run
at PRESET SPEED #2 (Parameter 32) when in JOG mode.
08 JOG REVERSE - Close TB-13B to TB-11 to JOG in the reverse direction. The drive will run
at PRESET SPEED #2 (Parameter 32 when in JOG mode.
When operating in JOG mode, the STOP signal and the AUXILIARY STOP
function (see Parameters 10-12), and the STOP key on the optional remote
keypad WILL NOT stop the drive. To stop the drive, remove the JOG command.
JOG REVERSE will operate the drive in reverse even if ROTATION
DIRECTION (Parameter 17) is set to FORWARD ONLY.
09 EXTERNAL FAULT: Sets TB-13B as a normally closed external fault input. Open TB-13B to
TB-11 to trip the drive.
10 INVERSE EXTERNAL FAULT: Sets TB-13B as a normally open external fault input. Close
TB-13B to TB-11 to trip the drive.
11 AUXILIARY STOP: When TB-13B is opened with respect to TB-11, the drive will decelerate
to a STOP (even if STOP METHOD is set to COAST) at the rate set into ACCEL/DECEL #2
(Parameter 42).
12 ACCEL/DECEL #2: Selects the acceleration and deceleration time programmed into Parameter
42 - ACCEL/DECEL #2.
WARNING