Manual

IMPORTANT NOTICE
The following , and information is supplied to you for your
protection and to provide you with many years of trouble free and safe operation of your LEESON
Electric product.
• Hazard of electrical shock! Capacitors retain charge after power is removed. Disconnect incoming
power and wait until the voltage between terminals B+ and B- is 0 VDC before servicing the drive.
• Hazard of electrical shock! Wait three minutes after disconnecting incoming power before
servicing drive. Capacitors retain charge after power is removed.
• Automatic starting of equipment may cause damage to equipment and / or injury to personnel!
Automatic start should only be used on equipment that is inaccessible to personnel.
• DRIVES MUST NOT BE INSTALLED WHERE SUBJECTED TO ADVERSE ENVIRON-
MENTAL CONDITIONS SUCH AS: COMBUSTIBLE, OILY, OR HAZARDOUS VAPORS
OR DUST; EXCESSIVE MOISTURE OR DIRT; VIBRATION; EXCESSIVE AMBIENT
TEMPERATURES. CONSULT LEESON ELECTRIC FOR MORE INFORMATION ON
THE SUITABILITY OF A DRIVE TO A PARTICULAR ENVIRONMENT.
• Severe damage to the drive can result if it is operated after a long period of storage or inactivity
without reforming the DC bus capacitors!
• Do not connect incoming AC power to output terminals U, V, or W, or terminals B+, B-!. Severe
damage to the drive will result.
• When operating in JOG mode, the STOP signal and the AUXILIARY STOP function (see
Parameters 10-12), and the STOP key on the optional remote keypad WILL NO
T stop the drive.
To stop the drive, remove the JOG command.
• JOG REVERSE will operate the drive in reverse rotation even if ROTATION DIRECTION
(Parameter 17) is set to FORWARD ONLY.
• DO NOT connect incoming AC power to output terminals U, V, and W or terminals B+, B-!
Severe damage to the drive will result. Do not continuously cycle input power to the drive more
than once every two minutes. Damage to the drive will result.
• Do not remove the EPM while power is applied to the drive. Damage to the EPM and/or drive
may result.
• The availability of controllers is restricted according to EN 61800-3. These products can cause
radio interference in residential areas. In this case, special measures can be necessary.
• Consult qualified personnel with questions. All electrical repairs must be performed by trained
and qualified personnel only.
Resale of Goods:
In the event of the resale of any of the goods, in whatever form, Resellers/Buyers will include the following language in
a conspicuous place and in a conspicuous manner in a written agreement covering such sale:
The manufacturer makes no warranty or representations, express or implied, by operation of law or otherwise, as
the merchantability or fitness for a particular purpose of the goods sold hereunder. Buyer acknowledges that it
alone has determined that the goods purchased hereunder will suitably meet the requirements of their intended
use. In no event will the manufacturer be liable for consequential, incidental or other damages. Even if the repair
or replacement remedy shall be deemed to have failed of its essential purpose under Section 2-719 of the Uniform
Commercial Code, the manufacturer shall have no liability to Buyer for consequential damages.
Resellers/Buyers agree to also include this entire document including the warnings and cautions above in
a conspicuous place and in a conspicuous manner in writing to instruct users on the safe usage of the
product.
WARNING
WARNING
CAUTION
CAUTION
DANGER
DANGER