Use and Care Manual

Two-person assembly is required. Please plan to
assemble the discharge chute when another person
can be available help to hold the discharge chute into
its position.
4. Make sure the spiral at the bottom is fully engaging with the
chute crank ange and tighten the two bolts on the chute
bracket. (See Figure 9b)
5. Tighten the nut which secures the directional chute control on
the handlebar.
M8 X 1
5
X 1
10 mm
13 mm
Figure 9a
Figure 9b
16 mm
10 mm
X 2
DIRECTIONAL CHUTE CONTROL
3. Secure the three ange keepers to the bottom of the chute
crank ange by sliding the bolts through the chute base holes,
sliding the keepers up from the bottom, then securing them
with the included nuts. (See Figure 8c)
M6 X 30 X 6
4
X 3
16 mm
10 mm
10 mm
13 mm
Figure 8c
Figure 8b
1. Slide the spiral end of the directional chute control lever into
the chute bracket.
2. Attach the directional chute control lever to the handlebar
through the hole on the left handle by sliding the bolt thru
the hole. Use the curved washer and nut to secure it to the
handlebar. Leave it nger tight for easier alignment later.
3. Secure the spiral end on the chute bracket by sliding on the at
washer and clevis pin. (See Figure 9a)
2. Place the discharge chute facing it forward over the chute
crank ange. (See Figure 8b)
11
|
Assembly