Use and Care Manual

1/8” (3mm)
1/8” (3mm) Cardboard
Scraper Blade
M8x25 (x2) M8x20 (x2)
Skid Shoe
TIRESSKID SHOES
The tires are over-inflated at factory for shipping purposes.
Check the pressure in the tires prior to usage. Reduce or increase
air pressure to ensure equal tire pressure to the manufacturer’s
recommended pressure. The recommended air pressure can be
found on the tire sidewall.
1. Place the machine on a solid, level surface.
2. Elevate the front of the machine slightly so the scraper blade
is 1/8" above the ground, and slide a piece of cardboard (about
half the thickness of the snow blower box) under the scraper
blade to elevate slightly.
3. Attach the skid shoes to the sides of auger housing with the
bolts and nuts. The shorter M8X20 bolts should be in the front
holes while the longer M8X25 bolts in the rear holes. Move the
skid shoes down as far as possible. Be sure both skid shoes are
adjusted evenly. Tighten securely. (See Figure 10)
Under any circumstance do not exceed manufacturer’s
recommended pressure. Excessive pressure when
seating beads may cause tire/rim assembly to burst
with force sufficient to cause serious injury. Refer to
tire sidewall for recommended pressure.
Maintain equal tire pressure in both tires at all times. If
the tire pressure is not equal in both tires, the machine
may not travel in a straight path and the scraper blade
may wear unevenly.
Keep tires free of gasoline and oil, which can harm
rubber.
Figure 10
M8 X 25 X 2
6
M8 X 20 X 2
10 mm
13 mm
4. Remove the 1/8” (3mm) spacer you used from under the
scrapper blade.
12
Two-Stage Snow Blower
»
Operator’s Manual
Assembly
|