Use and Care Manual

1. Release the auger clutch lever and shut off the engine.
2. Remove the clean-out tool from the clip which secures
it to the rear of the auger housing.
AUGER
When engaged, the augers rotate and draw snow into
the auger housing.
DISCHARGE CHUTE
Snow drawn into the auger housing is discharged out
the discharge chute.
Do not substitute. Use only original equipment shear
pins as supplied with your snow blower.
Never use your hands to clear a clogged discharge
chute. Shut off engine and remain behind handles until
all moving parts have stopped before unclogging.
Never use choke to stop engine.
CHUTE CLEAN-OUT TOOL
ENGINE ON/OFF SWITCH
The engine switch has two positions. OFF - engine will
not start or run. ON - engine will start and run.
RECOIL STARTER HANDLE
The handle is used to start the engine.
FUEL SHUT-OFF VALVE
The fuel shut – off has two position.
CLOSED
( )
- use this position to service, transport, or store the
unit.
OPEN
( ) - use this position to run the unit.
THROTTLE CONTROL
The throttle control regulates the speed of the engine
and will shut off the engine when it is moved to the
STOP
position. The throttle control moves between
FAST
,
SLOW
, and
STOP
positions.
CHOKE CONTROL
The choke control is used to choke the carburetor and
assist in starting the engine. The choke control slides
between the
CHOKE CLOSED
and
CHOKE OPEN
positions.
3. Grasp the tool rmly by the handle and push and
twist the tool into the discharge chute to dislodge the
blockage.
4. Refasten the clean-out tool to the mounting clip on the
rear of the auger housing.
5. Make sure the discharge chute is pointed in a safe direction
(no vehicles, buildings, people, or other objects are in the
direction of discharge). Restart the engine. While standing
in the operator’s position (behind the snow blower),
engage the auger control for a few seconds to clear any
remaining snow and ice from the auger housing and the
discharge chute.
Figure 11
15
|
Know Your Machine