Use and Care Manual

Refer to the Engine Operator’s Manual.

AUGER GEARBOX

The gearbox was lled with lubricant to the proper level at the

factory. Unless there is evidence of leakage or service has been

performed on the gearbox, no additional lubricant should be

required. If lubricant is required, use GL-5 or GL-6, SAE85-95, EP

gear oil lubricant. Do not use synthetic oil.

MAINTENANCE

ENGINE

GENERAL LUBRICATION

Lightly lubricate all moving parts of the machine at the end of the

season or every 25 operating hours.

Oil

Grease

Do not allow grease or oil get on friction disc, friction

plate or belts. Do not excessively oil the machine; extra

oil may enter the traction drive and cause the traction

drive belt to slip.

When lubricating auger shaft, remove shear pins

to apply oil inside the shaft and around spacers and

ange bearings found at either end of the shaft.

Remove the wheels to apply grease the wheel shaft.

Two-Stage Snow Blower

Operator’s Manual

Maintenance