Use and Care Manual

4. Carefully pivot the snow blower up and forward so that it rests
on the auger housing.
5. Remove the frame cover from the underside of the snow
blower by removing the screws which secure the cover. (See
Figure 20c)
7. Replace the auger belt by following instructions in reverse
order.
8. Bend the belt blocker to the home position.
6. Release the spring from the connecting hole in the braking
bracket. Bend the belt blocker a bit and move the braking
bracket away from the belt. Remove the belt from around the
auger pulley, and slip the belt between the support bracket and
the auger pulley. (See Figure 20d)
DRIVE BELT REPLACEMENT
If the drive belt becomes worn, oil-soaked, or otherwise damaged,
proceed as follows to replace the belt.
1. To prevent spillage, remove all fuel from tank by running engine
until it stops. Remove the key to avoid unintended starting and
allow unit to cool completely.
Figure 20c
Figure 20d
Figure 21a
Figure 21b
2. Remove the two screws that hold the belt cover in place and
set the cover aside. (See Figure 20a)
3. Remove the belt as follows.
a. Roll the auger belt off the engine pulley. (See Figure 20b)
b. Pivot the idler pulley toward the right to relieve tension.
c. Lift the drive belt off engine pulley. (See Figure 21a)
4. Carefully pivot the snow blower up and forward so that it rests
on the auger housing.
5. Remove the frame cover from the underside of the snow
blower by removing the screws which secure the cover. (See
Figure 20c)
6. Slip the drive belt off the pulley and between friction wheel
and friction wheel disc. (See Figure 21b)
a
b
c
10 mm
13 mm
Braking Bracket
Connecting Hole
Belt Blocker
1
2
3
4
22
Two-Stage Snow Blower
»
Operator’s Manual
Service
|