Use and Care Manual

8
Two-Stage Snow Blower
»
Operator’s Manual
Assembly
|
This snow blower was partially assembled at the factory. To assemble your machine follow the below instructions.
ASSEMBLY
ENGINE AIR FILTER COVER
HANDLEBARS
1. Remove wing nut and washer from the air lter cover.
2. Rotate the air lter cover by 180° so that the primer faces outside.
3. Install air lter cover and tighten wing nut. (See Figure 1)
1. Remove the axle pin from the axle. (See Figure 2a)
2. Remove the wheel from the axle.
3. Loosen the two bolts on the sides of the transmission housing.
4. Slide the handlebar slots in-between the transmission housing
and the washer. Finger tighten the bolts to hold the handle
in place. The handle with the chute crank sticker should be
installed on the left side.
M10 X 40 X 2
1
16 mm
10 mm
Figure 1
Figure 2b
Figure 2a
2
1
5. Align the holes in the handlebars with the upper holes on both
sides of the transmission housing. Insert the bolts and curved
washers and nger tighten to hold in place. (See Figure 2b)
6. Ensure the handlebars are at the same height , then tighten all
four bolts from the previous steps.