Owner's Manual
Table Of Contents
- Instruction Manual
- FOREWORD
- SCOPE OF DELIVERY
- REPLACEMENT PARTS/ACCESSORIES
- LEGAL INFORMATION
- SAFETY REMARKS
- GENERAL INFORMATION
- WARRANTY
- TABLE OF CONTENT
- PART DESIGNATIONS
- DISPLAYS
- PREPARATION
- CAMERA OPERATION
- CAMERA BASIC SETTINGS
- BASIC SHOOTING/RECORDING SETTINGS (PICTURE & VIDEO)
- BASIC SHOOTING SETTINGS (PICTURE)
- BASIC RECORDING SETTINGS (VIDEO)
- PICTURE MODE
- DRIVE MODE
- FOCUSING
- ISO SENSITIVITY
- WHITE BALANCE
- EXPOSURE
- SHOOTING MODES
- FLASH PHOTOGRAPHY
- VIDEO MODE
- REVIEW/PLAYBACK MODE
- CONTROL ELEMENTS IN REVIEW/PLAYBACK MODE
- INITIATE/EXIT REVIEW/PLAYBACK MODE
- SELECTING/SCROLLING THROUGH RECORDINGS
- INFO DISPLAYS IN REVIEW/PLAYBACK MODE
- CROPPED SECTION ZOOM
- DISPLAYING MULTIPLE RECORDINGS AT ONCE
- TAGGING/RATING OF RECORDINGS
- DELETING RECORDINGS
- PREVIEW OF LATEST RECORDING
- SLIDE SHOW
- VIDEO PLAYBACK
- OTHER FUNCTIONS
- LEICA FOTOS
- CARE/STORAGE
- FAQ
- MENU OVERVIEW
- INDEX
- TECHNICAL DATA
- LEICA CUSTOMER CARE
- LEICA ACADEMY
- Quick Start Guide
- Product Info
EN
FAQ
209
Camera is heating up Heat development due to high-res video recording (4K) or
serial exposures with DNG
Not a fault; allow camera to cool down if it gets too hot
Camera does not recognize the memory card The memory card is not compatible or defective Replace the memory card
Memory card is incorrectly formatted Format the memory card in the camera
(Caution: Loss of data!)
Menus and displays
Electronic viewfinder is dark EVF brightness is set too low Set the EVF brightness
Display language is not English - Select EnglishEnglish in the LanguageLanguage menu
Electronic viewfinder is dark Switchover between EVF and LCD incorrectly set Select a suitable setting
Viewfinder is out of focus Check the diopter setting and adjust as needed
The LCD panel is to dark or too bright/not clear The brightness setting is incorrect Adjust the display brightness
Viewing angle is too small View the LCD panel at a perpendicular angle
Brightness sensor is blocked Make sure that the brightness sensor is not blocked
FavoritesFavorites menu does not appear The favorites menu is empty Add at least one function
Live View stops suddenly or doesn't start The camera is hot due to high ambient temperature,
extended Live View operation, extended video recording
or serial exposures
Allow camera to cool down
The brightness in Live View mode is not the same
as in the pictures
The brightness settings for the LCD panel have no
influence over the exposures
Adjust the brightness settings as needed
Exposure preview is deactivated Activate the function
The number of remaining exposures does not
count down after a picture is taken
The exposure requires only very little memory space This is not a fault; the number of remaining exposures
is calculated as approximations
Recording
Image noise appears on the LCD panel/in the
viewfinder when the shutter button is pressed to
the first pressure point
The gain is increased to aid image composition if the
object is insufficiently lit with reduced aperture opening
Not a fault – picture quality will not be impacted
LCD panel/viewfinder deactivates after a very
short time
Power Save settings are activated Change the settings as needed
The display switches off after the picture is taken/
the LCD panel goes dark after the picture is taken
Flash loads after picture is taken, LCD panel deactivates
during load time
Wait until the flash is loaded