Operating Instructions

Detailed guide / Review mode / 157
3. You can use the direction pad (1.29) to show
the other saved pictures in the monitor or
select them.
Pressing left or up on the direction pad takes
you to the pictures with lower numbers, right
and down to those with higher numbers. Up
and down moves you from line to line. After
the highest and lowest numbers, the sequence
of pictures arranged in an endless loop starts
again from the beginning.
The selected picture is identified by a yellow
number.
Zoom and trimming selection for reviewing
single pictures
To assess a single picture more accurately on the
monitor, you can enlarge it by up to 16x in several
stages and select any trimming. Likewise, it is
also possible to view up to six – considerably
reduced – pictures in sequence on the monitor.
Notes:
Zooming and selecting the trimming is not possible
for video recordings.
The more the picture is enlarged, the more the
quality of reproduction in the monitor is reduced,
due to the proportionally lower resolution.
It may not be possible to enlarge pictures from
other types of camera.
Setting the function/Selecting pictures:
1. Select the desired picture as described in the
section “Reviewing single pictures” on p.155?
under points 1 and 2.
The further steps are different depending on
the selected function.
Enlarging the picture and selecting
the trimming
2. Press the zoom lever (1.10) to the right (into
the telephoto position).
The previous displays disappear from the monitor
and the picture previously shown is enlarged
by 2x.
The enlargement factor can be increased for
even smaller trimmed areas by repeatedly
pressing the zoom lever (up to 4x in total) up to
a maximum enlargement of 16x. Pressing the
zoom lever to the left (into the wide-angle
position) reduces the picture.
The displays change according to the current
setting.