Operating Instructions

Detailed guide / Review mode / 178
13. Start automatic playback by pressing right on
the direction pad.
Some of the displays change. For a short time,
the following appear
_ in the header
p ALL SLIDE SHOW;
_ below it
START SLIDE SHOW, and
_ below that
STOP: MENU to indicate how
you stop playback.
Automatic playback then proceeds with short
dark intervals between the pictures until you
press the
MENU button. The only display is
the file and consecutive picture number in the
top right.
14. Press the
MENU button to stop automatic
playback.
The picture no longer changes, the message
END OF SLIDE SHOW appears in the center
of the screen for a short time and then the
original displays appear on the monitor.
Setting the LCD monitor brightness
The brightness of the LCD monitor on the LEICA
DIGILUX 1 can be set so that you can adjust it
optimally for any situation, i.e. the prevailing light
conditions.
Notes:
The monitor brightness setting has an effect on
the battery life: the brighter it is, the more power
it consumes and therefore the shorter the life.
For this reason, the brightness is always reset to
the default value when the camera is turned off.
Setting the function:
1. Press the
MENU button (1.27). It makes no
difference whether you are in record or review
modes.
2. Press right on the direction pad (1.29) to open
the default settings menu
h SETUP.
3. Select the desired brightness level by pressing
left and/or right on the direction pad.
The selected level of the scale is marked in
yellow. At the two maximum settings, the
relevant arrow disappears.
4. Press the
MENU button again to exit the menu
system.
Setting the acknowledge tones
With the LEICA DIGILUX 1, you can decide whether
you want your settings and other functions to be
acknowledged by an acoustic signal – two
volumes are available, or whether operation of the
camera and actually taking photographs should be
predominantly free of noise.
The acknowledgement is a beep, which sounds for
each step and when the focus and exposure are
calculated and saved when the shutter release is
pressed down halfway.
Setting the function:
1. Press the
MENU button (1.27). It makes no
difference whether you are in record or review
modes.