Operating Instructions

Miscellaneous / 187
Malfunctions and troubleshooting
1. The camera does not respond when I turn it
on.
1-1. Is the battery correctly inserted or the
mains/charging unit correctly connected?
1-2. Does the battery have sufficient charge?
Use a charged battery.
2. The camera turns itself off again as soon as
I turn it on.
2-1. Does the battery have sufficient charge to
operate the camera? Charge the battery or
insert a charged battery.
2-2. Is there any condensation? This occurs if the
camera is moved from a cold place to a hot
place. Wait until the condensation has
evaporated.
3. I cannot save a picture.
3-1. Is a memory card inserted?
3-2. The record/review selector is not set to one
of the record modes.
3-3. The memory card is full. Delete pictures you
no longer need before you take new ones.
4. The picture is not shown on the monitor.
4-1. Is the monitor turned off?
5. The LCD monitor is too bright or too dark.
5-1. Set your preferred monitor brightness.
6. The picture(s) on the monitor is/are out of
focus.
6-1. Set the focus correctly or set an automatic
focussing mode (AF, macro) and press the
shutter release to the 1st pressure point.
7. The flash does not work.
7-1. The flash unit is turned off; select another
flash mode.
8. I cannot review the picture.
8-1. Is a memory card inserted?
8-2. There is no data on the memory card.
8-3. The record/review selector is not set to one
of the review modes.
9. I cannot view the picture on a television.
9-1. Check whether the television and the camera
are connected correctly.
9-2. Set the television to the AV input to which the
camera is connected.
10. The camera is connected to a computer but I
cannot transfer data.
10-1.Check whether the computer and the camera
are connected correctly.