Operation Manual

Rugby 410/420 DG Setup14
Changing the Setup
Options
When entering the setup screen, the EXIT window will be highlighted.
To change the setup options in this window the buttons are used in the
following way:
Press the Star button and the cursor will become a thick border around
the selected parameter. Once selected, use the Up and Down buttons to
change the parameter.
)
If no button is pressed, the display will revert to the main display after
ten seconds.
Head Speeds The Rugby can be set to any of four different head speeds – 5, 10 , 15,
or 20 rps. (300, 600, 900, 1200 rpm)
Select the head speed that provides the best performance for your appli-
cation. The selected head speed is shown on the bottom, right corner of
the main display screen.
HI Function – Turns the H.I. function on and off.
Automatic, Manual or Manual with Grade.
Wind Sensitivity (1-5) – (1) for calm days, (3) for normal days,
(5) for extremely windy days.
Beam Masking – Turns the beam off in the selected quadrants.
Use the STAR button to select or deselect the setup parame-
ters and exit the setup screen.
Use the UP and DOWN buttons to move the cursor or change
the selected parameter.
Use the X/Y button to switch between the first and second
page of the setup screen.
Beam masking requires using also the X/Y button.
With the beam masking option selected, press the X/Y button
to turn the beam on or off in the selected quadrant.
Use the Up and Down buttons to move around the quadrants.
The quadrant will become solid and dark when selected for the
beam to be masked (off) in the quadrant.
Select the EXIT window, then press the Star button to exit and
return to the main display.