Operation Manual

Rugby 410/420 DG 17Setup
4.3 Additional Setup Options
Additional setup options may be accessed in a second setup screen.
Changing the Setup
Options
When entering the setup screen, the EXIT window be highlighted.
To change the setup options in this window the buttons are used in the
following way:
Press the STAR button and the cursor will become a thick border around
the selected parameter. Once selected, use the UP and DOWN buttons
to change the parameter.
)
If no button is pressed, the display will revert to the main display after
ten seconds.
+
From the main operating screen, Press and hold the UP
button, then press the STAR button to access the
second level setup screen.
Selects beam masking at the diagonals or at the corners.
Allows the Rugby to always start up with no beam
masking, or to save and start up with the last beam mask
setting used.
Allows the Rugby to start up with the H.I. Alert automat-
ically turned on, or turned off.
Allows the operator to disable the negative grade func-
tion of the Rugby. When disabled, negative grade cannot
be entered in the grade displays.
The remote control is enabled only when a remote is to
be used with the Rugby. It is normally off to conserve
battery power.
The STAR button is used to select or deselect the setup param-
eters.
The UP and DOWN buttons are used to move the cursor and
change the parameters.
Select the EXIT window, then press the STAR button to exit and
return to the main display.