Operation Manual

Rugby 410/420 DG Safety Directions38
Although the product meets the strict regulations and standards which
are in force in this respect, Leica Geosystems cannot completely
exclude the possibility that the product may be disturbed by very
intense electromagnetic radiation, for example near radio transmit-
ters, two-way radios or diesel generators.
Precautions:
Check the plausibility of results obtained under these conditions.

Warning If the product is operated with connecting cables attached at only one
of their two ends, for example external supply cables, interface cables,
the permitted level of electromagnetic radiation may be exceeded and
the correct functioning of other products may be impaired.
Precautions:
While the product is in use, connecting cables, for example product to
external battery, product to computer, must be connected at both
ends.
Use of product with radio devices:

Warning Electromagnetic radiation can cause disturbances in other equipment,
in installations (e.g. medical ones such as pacemakers or hearing aids)
and in aircraft. It can also affect humans and animals.
Precautions:
Although the product meets the strict regulations and standards which
are in force in this respect, Leica Geosystems cannot completely
exclude the possibility that other equipment may be disturbed or that
humans or animals may be affected.
• Do not operate the product in the vicinity of filling stations or
chemical installations, or in other areas where an explosion hazard
exists.
• Do not operate the product near to medical equipment.
• Do not operate the product in aircraft.
• Do not operate the product for long periods with it immediately
next to your body.
9.9 FCC Statement, Applicable in U.S.

Warning Changes or modifications not expressly approved by Leica Geosystems
for compliance could void the user's authority to operate the equip-
ment.

Warning This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate frequency energy and,
if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation.