Operation Manual

Connecting to other equipment
- 192 -
Preparations:
Turn on the camera and the PC.
Remove the card before using the pictures in the internal memory.
Connect the camera to a PC via the USB connection cable A
(supplied).
• Do not use any other USB connection cables except the supplied one. Use of
cables other than the supplied USB connection cable may cause malfunction.
Press 3/4 to select [PC], and then press [MENU/
SET].
• If [USB MODE] (P37) is set to [PC] in the [SETUP] menu in
advance, the camera will be automatically connected to the PC
without displaying the [USB MODE] selection screen. Since
there is no need to set this each time you connect to the PC, it
is convenient.
• When the camera has been connected to the PC with [USB MODE] set to
[PictBridge(PTP)], a message may appear on the PC’s screen. Select [Cancel] to close
the screen, and disconnect the camera from the PC. Then set [USB MODE] to [PC]
again.
Acquiring of still pictures and [MOTION JPEG] motion pictures
(other than [AVCHD] motion pictures)
A USB connection cable (supplied)
• Make sure the plug is aligned correctly and that it is inserted straight.
(Otherwise, it may cause deformation on both sides resulting in malfunction.)
B Align the marks, and insert.
• Use a battery with sufficient battery power. If the remaining battery power becomes low while
the camera and the PC are communicating, the alarm beeps.
Refer to
“Disconnecting the USB connection cable safely” (P193) before disconnecting the
USB connection cable. Otherwise, data may be destroyed.
MIC
REMOTE
AV OUT/DIGITAL
AV OUT/DIGITAL
USB MODE
PLEASE SELECT
THE USB MODE
PictBridge(PTP)
PC
SELECT SET
MENU