Operation Manual

- 21 -

Preparation

Inserting and Removing Card and Battery

• Turn the power switch to [OFF] and confirm that the lens barrel is retracted.

• Close the flash.

Set the camera ON/OFF switch to OFF,

slide the release lever in the direction of

the arrow, and open the card/battery

door.

• Use only the Leica battery BP-DC9 E/U (P7).

• We cannot guarantee the quality of any other

batteries.

Insert battery and card.

Be sure to insert in the correct

orientation.

Battery: Push it in until it is locked by the

lever A. To remove, pull this lever in the

direction of the arrow.

Card: Push it down until it clicks into

place. To remove, push it further down

until it clicks, then pull it out upright.

B: Do not touch the connection terminals of the

card.

•

The card may be damaged if it is not fully inserted.

1:Close the card/battery door.

2:Slide the release lever in the direction

of the arrow.

• If the card/battery door cannot be completely

closed, remove the card, check its direction and

then insert it again.

LOCK

OPEN

LOCK

OPEN