Use and Care Manual

Take assembled SEAT PANEL (6) and one of the arm frames,
Attach the SEAT PANEL (6) to the inside of the arm frame,
secure with the indicated nuts and bolts.
Insert the other arm frame
on the other side and
secure loosely with
nuts and bolts.
Take the Lower Support
Beam (5) and secure
under the seat between
the arm frame with
nuts and bolts.
Once the bottom half is finished,
take the BACK PANEL (7) and
place it gently on part 4
of the arm frame.
Secure with indicated hardware
in the diagram.
Tighten all nuts, bolts,
and screws once
every part and
assembled pieces
are in place.
Congratulations
on your assembly!
STEP 2: Assembling the Bottom Half
STEP 3: Assembling the Upper Half
STEP 4: Finish
Take one piece of the following parts with a letter “R” behind
each number: 1 , 2 , 3 , 4 , 8 (“R” = Right)
1: Part 1 to part 4
2: Part 3 to part 2
3: Part 2 to part 1
4: Part 4 to part 3
5: Part 8 to Part 2 & 3
Use indicated hardware,
directed by diagram.
REPEAT steps 1 through 5 above using parts labeled
with a letter “L” (“L” = Left) after the part number.
C
A
A
A
4R
3R
1R
8R
2R
7
B
B
6
5
A
D
D
A
A
Left
Right
PORCH ROCKER
ITEM # TX 36000, TX 36002, TX 36005 & TX 36007
A B C D
Mallet
Socket & Wrench
Phillips
Screwdriver
Tools Required for Assembly
13mm
NUT & BOLT
(8x120mm)
NUT & BOLT
(8x70mm)
SCREW
(4x40mm)
X 12pcs X 4pcs X 2pcs
SCREW
(8x120mm)
X 4pcs
Tools Included
IMPORTANT:
READ CAREFULLY BEFORE BEGINNING
Recessed Hole
Pre-Checked
PARTS AND HARDWARE LIST
1 2
6
3
7
4
85
ARM REST
LOWER
SUPPORT
BEAM
FRONT LEG
SEAT PANEL
DIAGONAL
SUPPORT
BACK PANEL
VERTICAL
SUPPORT
RUNNER
X 2pcs X 2pcs X 2pcs X 2pcs
X 1pc
X 1pc
X 1pc
X 2pcs
1. Do not tighten bolts until fully assembled.
2. Rescessed holes to face outward.
3. Insert bolts with washer and secure with washer and nut.
4. Pre-checked side must always face downward or inward.
STEP 1: Assembling the Rocker Arm Frame
Do not use power tools because
they may damage the hardware
or split the wood.