User guide

Page 6 of 16
1.Setting up the iPod Speaker Dock
Insert the Mains Plug into a suitable wall socket and turn the socket on.Turn the ON/OFF Switch
at the rear of the Speaker Dock to the ON position.Press the STANDBY button to turn the Speaker
Dock on.
2.Using the Remote Control
The Remote Control can be used to operate the Speaker Dock. Before using the Remote Control,
the Safety Tab should be removed.
Simply pull out the Safety Tab from the remote control, as shown below.
To use the Remote Control, simply direct it towards the front of the Speaker Dock and press the
desired buttons.
DON’T FORGET! When replacing the battery make sure that you use the same size and type.