Instruction manual

20
RADIO OPERATION
1. Enter FM Function
In the turn-on or playing status, press the FM button on the remote control (or front
panel) to enter FM mode.
2. Select Bands
1) Directly input frequency: press the T/F button on the remote control, then input the
frequency that you want. The range of FM frequency is from 87.50MHz to 108.00
MHz.
2) Select the band by pressing Tune- or Tune+ button: press this button to adjust the
frequency up or down a step. The step of FM is 0.05 MHz.
3) Select saved stations by pressing number buttons. For example: press 10+ button
twice, 5 button once, you may select the 25th saved station. Press the CH- or CH+
button to switch the previous or next band.
4) Automatically search bands: press the SEARCH button, this system starts searching
bands from low to high frequency automatically. The searched band are saved
automatically. Press this button again to stop searching.
3. Save Bands
Press the SAVE button to save the current frequency of band. For example: if you
want to save 99.30 MHz in 28th cell, press 10+ button twice and 8 button once,
press T/F button to input 9 9 3 0, then press SAVE button.
4. Soundtrack Selection
To select Mono or Stereo while in FM mode, press MO/ST button. When you select
stereo, the display shows a stereo signal. If the signal is not strong enough, you
cannot select Stereo.
5. Exit FM/AM mode
1) Press the DVD, TAPE or AUDIO-IN button on the remote control or front panel
to exit FM status, and switch to the according modes.
6. RDS Radio Funciton
In FM status, press the RDS button on the remote control to switch to RDS radio mode
If there is RDS signal surrounds, you will get the information of four items:
1) PS: Program service name.
2) RTY: Program type.
3) RT: Radio text.
4) CT: Clock time and date.
(Note: In RDS radio mode, you can use the options as FM mode. Such as select bands,
save bands, soundtrack selection etc.)