Operation Manual

HINTS FOR BEST RECEPTION:-
- AM : THE RECEIVER HAS A BUILT-IN AM BAR ANTENNA. IF AM RECECPTION IS WEAK, SLIGHTLY ROTATE
OR RE-POSITIONING OF THE UNIT WILL USUALLY IMPROVE THE AM RECEPTION.
- FM : THE RECEIVER HAS A BUILD-IN FM WIRE ANTENNA HANGING AT THE REAR CABINET. THIS WIRE
SHOULD BE TOTALLY UNRAVELED AND EXTENDED FOR BEST RECEPTION.
PHONO
NOTED:
- REMOVE THE STYLUS PROTECTOR.
- BE SURE THAT THE TONE ARM
IS BEING DETACHED FROM THE TONE ARM
REST BEFORE OPERATING AND RE-SECURED AGAIN AFTERWARDS.
1. SELECT TO “ PHONO ” FUNCTION.
2. SET THE SPEED SELECTOR TO THE PROPER POSITION DEPENDING ON THE
RECORD TO BE PLAYED.
3. PLACE THE RECORD ON THE PLATTER (USE THE SPINDLE ADAPTOR IF REQUIRED).
4. LIFT THE TONE ARM FROM THE REST AND SLOWLY MOVE IT TO THE RECORD SIDE.
THE PLATTER WILL START TO ROTATE.
5. PLAC
E THE TONE ARM TO THE DESIRED POSITION OF THE RECORD.
6. ADJUST THE V
OLUME TO THE DESIRED LEVEL.
7. AT THE END OF RECORD, THE PLATTER WILL AUTOMATICALLY STOP ROTATING. LIFT THE TONE ARM
FROM THE RECORD AND RETURN IT TO THE REST.
8. TO STOP MANUALLY, LIFT THE TONE ARM FROM THE RECORD AND RETURN IT TO THE REST.
REMARK : AT SOME OF THE RECORD, THE AUTO-STOP AREA IS OUT OF THE UNIT SETTING, SO IT WILL
STOP BEFORE THE LAST TRACK FINISH. IN THIS CASE, SELECT THE AUTO-STOP SWITCH (16) TO “ OFF
“ POSITION, THEN IT WILL
RUN TO THE END OF THE RECORD BUT WILL NOT STOP AUTOMATICALLY (TURN
OFF THE UNIT BY POWER BUTTON OR SWITCH BACK THE AUTO-STOP SWITCH TO “ ON “ POSITION TO
STOP THE PLATTER TO ROTATE). THEN PUT BACK THE TONE ARM TO THE REST POSITION.
LINE OUT CONNECTION
YOU CAN CONNECT THE SYSTEM TO YOUR HI-FI SYSTEM BY CONNECTING THE LINE OUT SOCKET (14) TO
THE AUXILIARY INPUT SOCKET WITH A RCA CABLE (NOT INCLUDED).
GB-2
Products with the CE marking comply with the EMC Directive (2004/108/EC) and the
Low Voltage Directive (2006/95/EC) issued by the Commission of the European Community.
The declaration of conformity may be consulted at http://www.stl.nl/supportfiles/ices/CE/284bfgwmebr5ty51.pdf
This symbol indicates that the relevant electrical product or battery should not be disposed of as general household
waste in Europe. To ensure the correct waste treatment of the product and battery, please dispose them in
accordance to any applicable local laws of requirement for disposal of electrical equipment or batteries. In so
doing, you will help to conserve natural resources and improve standards of environmental protection in treatment
and disposal of electrical waste (Waste Electrical and Electronic Equipment Directive).
Service and support
For information: http://www.axxion-electronics.com/
For support: http://axxionsupport.zendesk.com
Axxion helpdesk:
Germany 0900-1520530 (Local charges)
The Netherlands 0900-23553626 (Local charges + 1ct P/min)
Belgium 02-6200115 (Local charges)
France 0170480005 (Local charges)
The helpdesk is accessible from Monday to Friday from 9 AM till 6 PM.
In case your device needs repair, our helpdesk will redirect you to your local dealer.
Axxion offers service and warranty in accordance to European law, which means that in case of repair (both during and after
the warranty period), you should contact your local dealer.
Please note: It is not possible to send products to directly Axxion for repair.
Important note: If this unit will be opened, or accessed in any way by a non-official service center, the warranty expires
immediately.
STL Group P.O Box 3092, 5902
RB Venlo, The Nethrlands