User Manual

33
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Step 11. HOOD INSTALLATION
(Refer to Figure 53) All models must have a hood installed prior to
operating.
Install hood by sliding it into the slots on the lower edge of the cabinet top.
FINISHING REQUIREMENTS - Wall Details
Complete finished interior wall. To install the appliance facing flush with
the finished wall, position framework to accommodate the thickness of
the finished wall (Figure 53).
See Page 5 for Cold Climate Insulation
and Page 8 for Clearances
Top of Appliance
3"
(76 mm)
This area must
remain clear of
combustible
materials.
1 in. Min.
(25 mm)
Figure 53 - Combustible Wall Framing
Combustible
Finished
Wall Materials
Combustible material may
touch appliance top.
Hood
3" Clearance Min.
Header
LENNOX HEARTH PRODUCTS • MERIT
®
SERIES DIRECT-VENT GAS FIREPLACES • MODELS MLDVT-30/35/40/45 • INSTALLATION INSTRUCTIONS