Installation Guide

A:
1. Drain Plug
2. Electric pump
3. Water tap
4. Outlet pipe
While installing the electric pump, do
not use too soft rubber tube for the
inlet pipeline, avoiding to be sucked
flat.
The foot valve should be vertically
placed and installed 30cm from
water bottom to avoid sucking in
sands and stones (B2);
Joints of the inlet pipelines should be
sealed with the least elbows, no
water can be sucked.
Diameter of the inlet pipe should be
at least in accordance with that of
the water inlet, so as to avoid too
much water loss which will influence
outlet performance.
Pay attention to drop of water level
while using, the foot valve should not
be above the water surface (B1).
In case the inlet pipe is longer than
10m or its lifting height exceeds 4m,
the pipe diameter should exceed
diameter of water inlet of the pump.
Ensure the pumped will not be
affected by pipeline pressures while
installing the pipelines.
Filter should be installed in inlet
pipelines so as to avoid solid
particles to enter into the electric
pump.
1.)
2).
3).
4).
5).
6).
7).
8).
C: Installation Precautions of the
outlet pipeline
Pipe diameter of the outlet pipeline
should be at least in accordance with
that of the water outlet, so as to reduce
its voltage drop, high flow rate and
noise to the minimum.
B: Installation precautions for inlet
pipelines
Incorrect Installation Diagram
Correct Installation Diagram
A
B
5. Filling plug
6. Tie-in
7. Inlet pipe
8. Foot valve
7
B1 B2
12
3
4
5
6
7
8