User manual

AP Configuration Using Locator

While entering the Locator utility, the Locator will automatically search the

available WAP-1001 on the same network. Locator will show the Device Name,

Device Type, IP Address, Ethernet MAC Address and Firmware Version in first

page. Before start using Locator, make sure you disable personal firewall

installed in you PC. (Ex. Windows XP personal firewall)

If you have 2 Fast Ethernet Adapter or more, you can choose enable one Fast

Ethernet Adapter for enter with Locator utility.

AP Configuration Using Web User Interface

Before Setup...

 Verify the IP address setting

You need to configure your PC’s network settings to obtain an IP address.

Computer use IP addresses to communicate with each other across a network,

such as the Internet.

1. From the taskbar, click the Start button, select Settings > Control

Panel. From there, double-click the Network connections icon.

2. Right click the Local Area Connection icon Properties; select the

TCP/IP line for the applicable Ethernet adapter. Then, click the

Properties button.

3. Click the IP Address tab page, select USE the following IP

address, type 192.168.1.X (X can be from 1 to 254,but

192.168.1.20 is for WAP-1001 already, please avoid the confliction)

in the IP Address field and 255.255.0.0 in the Subnet Mask field,

then click OK button.

Start Setup by Browser...

1. After getting the correct connection, start the web browser (make

sure you disable the proxy) and type 192.168.1.20 (The default IP

of outdoor AP ip Address) in the Address field. Press Enter.