User manual

26
Changing SNMP Settings
Under System Configuration, click SNMP to display and change settings for the
Simple Network Management Protocol.
To communicate with the access point, the SNMP agent must first be enabled
and the Network Management Station must submit a valid community string for
authentication. Select SNMP Enable and enter data into the fields as described
below. When you are finished, click “Apply”
Setting Description
SNMP Enables or disables SNMP.
Contact Sets the location string that describes the system location.
Maximum length is 255 characters.
Community
Name (Read
Only)
Specifies a community string with read-only access.
Authorized management stations are able to retrieve MIB
objects. Maximum length is 32 characters.
Community
Name (Read
Write)
Specifies a community string with read-write access.
Authorized management stations are able to both retrieve
and modify MIB objects. Maximum length is 32 characters.
Trap
Destination
IP Address
Enter the IP address of the trap manager that will receive
these messages.
Trap
Destination
Community
Name
Enter the community name of the trap manager that will
receive these messages.